...
The network scan can be setup directly in the Adminstration Interface. First click on the disocvery source in the home page.
Then click on the "See nework scan list" button:
You can list the current network scan in the Discovery menu.By default you will have two samples.
You can enable new scan with the Add new scan button.
And you will see the configuration of a new scan:
You must set up the following parameters:
- nameName
- IP range: must match a nmap command range definition
- Scan interval, in minutes
- You can setup notes about this scan
Adding a new scan will automatically enable it and your new hosts or your new tags will appears in a few minutes.