Introduction
Shinken Enterprise has the ability to distinguish between “normal" checks and "volatile" checks. The Is Volatile option in each check definition allows you to specify whether a specific check is volatile or not. For most people, the The majority of all monitored checks will be mainly non-volatile (i.e. “normal"). However, volatile checks can be very useful when used properly in the right context.
How to enable this option?
| This option can be enabled on the Check configuration page |  |
What Are They Useful For?
...
- Contacts are notified about the problem (if that's what should be done). Notification intervals are ignored for volatile checks.
- The event handler for the check is run (if one has been defined)
These events normally only occur for checks when they are in a non-OK state and a hard state change has just occurred. In other words, they only happen the first time that a check goes into a non-OK state. If future checks of the check result in the same non-OK state, no hard state change occurs and none of the events mentioned take place again.
...